Layton Foundation Pros
Piering and Underpinning in Layton, UT
Piering and underpinning in Layton, UT using helical and push piers to stop settlement. Free estimates, written scope before any pier goes in.
Serving Layton and nearby communities.
Piering and underpinning stops a settling foundation from dropping further. The method transfers the building's weight down to load-bearing soil or bedrock. Layton Foundation Pros uses galvanized helical piers and steel push piers rated for the clay and sandy mix found on Davis County bench lots, where seasonal moisture swings cause uneven settlement around footings.
Most jobs start with a load assessment to figure out how many piers a wall or corner needs. Then it's excavation at access points, then pier driving. This is structural work, so it typically runs through a building permit before anything gets installed.
What's included
What's included with Piering and Underpinning
Typically included: site evaluation, pier spacing plan, excavation at pier points, pier installation to bearing strata, load transfer bracket attachment, backfill and compaction.
Optional: additional piers for perimeter-wide settlement, interior push piers for slab support, post-install monitoring visit.
Customer prep: clear access around the foundation perimeter, move landscaping or fencing near planned pier points, note any sprinkler lines in the work area.
Want a clearer scope?
Get a Free EstimateHow it works
How our Piering and Underpinning process works
Step 1Load Assessment
We analyze weight distribution on the affected wall to plan pier spacing.
Step 2Access Excavation
Small excavation points open along the foundation at each pier location.
Step 3Pier Driving
Piers are driven or screwed down until they reach stable bearing soil.
Step 4Load Transfer
Brackets connect piers to the foundation to carry structural weight.
Step 5Leveling Adjustment
Hydraulic jacks raise the foundation back toward its original position.
Step 6Site Restoration
Excavated areas get backfilled and compacted to match the yard grade.
Materials
Materials and methods for Piering and Underpinning
Layton's bench-area soil moves enough each year that pier choice matters as much as installation quality.
Steel Push Piers
Deliver deep support by riding weight down to bedrock, a good fit for heavier two-story homes on sloped Layton lots.
Helical Piers
Screw-driven for torque-rated support, useful where clay layers vary in depth across a single foundation wall.
Underpinning Brackets
Connect piers to existing footings so load transfers evenly instead of concentrating at one point.
Hydraulic Lift Systems
Allow controlled, incremental lifting so a settled corner comes back level without overcorrecting.
Galvanized Coatings
Protect steel piers from corrosion in Utah's freeze-thaw cycle and seasonal groundwater contact.
Compacted Fill Material
Stabilizes the soil around new piers so backfilled areas don't re-settle the following spring.
Questions on materials?
Get a Free EstimateFAQs
Piering and Underpinning FAQs
How much does piering cost per pier in Layton?
Most piers run in the low thousands installed. Total project cost is driven by how many piers the affected wall needs and how deep they have to go to reach bearing soil.
Will underpinning disturb my landscaping or yard?
Excavation happens at specific pier points, not the whole yard. Plants or fencing right at those spots usually need to move before we start.
How do I know if I need piering instead of crack injection?
Cracks that widen diagonally, doors that stick, or a visibly settling corner point to structural movement that piering corrects. Small hairline cracks with no movement are often handled with injection alone.
Can piering be done without digging up my basement floor?
Exterior perimeter piers handle most wall settlement without touching interior floors. Interior push piers are only used when a slab itself needs support.
Does piering stop future settlement for good?
Properly installed piers transfer load to stable soil below the active zone. They're designed to hold even as the surface soil around them keeps shifting seasonally.
Before & after
Before and after Piering and Underpinning
Before 
After
Timeline
How long does piering and underpinning take?
- 01
Stage 1
A typical pier job moves from a site visit to a finished, leveled foundation over a short, defined timeline.
- 02
Site evaluation and plan
same day
Need a schedule that fits?
Get a Free EstimateCodes & permits
Permit filing**: about 1 week.
Pier installation: 1 to 3 days depending on pier count. Backfill and site cleanup: same day as install. Final level check: at project close-out. <!-- rover-autofix-links -->
| Typically needs a permit | Often no permit |
|---|---|
| [Home](/) | — |
| [Contact](/contact) | — |
Need help with permits?
Get a Free EstimateNext step
Get a Piering and Underpinning estimate in Layton
Settling corner? Sticking doors? Call Layton Foundation Pros at (435) 666-7601 for a free, written estimate, no obligation, before any pier goes in.
More services
Other Foundation Repair services
Foundation Repair
Foundation repair in Layton, UT: helical piers, push piers, and crack injection sized to Davis County clay soil, free estimates.
Wall Stabilization
Basement wall stabilization in Layton, UT for bowing walls using steel anchors and carbon fiber straps. Free estimates, written scope on paper first.
Foundation Crack Repair
Foundation crack repair in Layton, UT with epoxy and polyurethane injection. Fast, same-day fixes and free estimates from Layton Foundation Pros.
Ask about Piering and Underpinning
Tell us about the project and how to reach you.